PDA

View Full Version : heli noob needs blade cp model


quadcopter
11-25-2006, 10:01 AM
I just purchased a blade cp and bought g3 and I got the 3.5 update. I still can't find a blade cp model in g3.5. I flew it once and wrecked it. I want to fly it on g3.5 before I try the real thing again. Can anyone help me...

I found out about the trainer blade at the hobbie shop after I bought the cp from the pawn shop... good deal ( I think ) $130.00 us. I am still kicking myself. Did I screw up bad here guys.

it has carbon fiber symertrical blades and a aluminum swash plate and upgraded servos and had no scratches until I wrecked it. I had to replace the tail boom shaft and I got the crash kit also.

can anyone make me a cp for g3.5 please.....

opjose
11-25-2006, 02:22 PM
This gets asked a lot and answered a lot.

The AXE CP is very close to the Blade CP in behaviour.

Did you make a mistake?

As a newbie... well, yes.

Helis are hard to learn, and the electrics are even harder in real life than in G3...

It is recommended that you start out with a larger glow heli which are easier to control and see....

You NEED HELP learning about helis as there is a lot to it.

Join a club, get into their training program to find all of this out.

The CX's practically fly themselves, yet a newbie will find them hard and frequently crash them too.