Correct Switch Location for Heli Flyers

[ssrobzoom]

Is Knife Edge going to produce the correct Kit or Transmitter for the Helicopter Flyer?

[phrank]

I would guess not.
Once the units hit production and start shipping it's virtually impossible to switch direction. Imagine all the confusion that would occur if half were using one type of Interlink while the other half the other type.
I admit, I was first put-off by the unconventional location of the switch/knob, but once I flew for a few hours, it just isn't an issue with me anymore.
If it's troublesome, the mod is relatively easy if you're an experienced modeler.
If you can solder your own Dean's plugs and ESC on your common ARF or kit, the mod should be a breeze. Of course you risk voiding your warranty.

Frank...

Is Knife Edge going to produce the correct Kit or Transmitter for the Helicopter Flyer?