Interlink with DX7

[Mx101]

Having trouble connecting my DX7 through the Interlink controller in G4. Multiple channels seem ties to one control stick, and no switches are recognized?

Any one else seen this problem?

[nemo_uk]

I just tried it my DX7, you need to have a model that is an aircraft (ARCO) selected in the menu on the DX7 not a helicopter (HELI)

[Mx101]

Thanks I'll try that. Does that mean that I cant use the mixing etc on with G4 in heli mode?

Steve

[nemo_uk]

I'm not 100 % sure. I think G4 is expects "simple" signals (hence ARCO works) from the TX and then G4 does any mixing in the sim. You can control how the TX channels mix for each aircraft within the aircraft editor in the sim.

[Mx101]

Your right about the ARCO it does work. I was trying to use the interlink with he DX7 in full pass through mode which theoretically would allow to test your DX7 programming with the model. Apparently you can change the settings in the heli (TREX600N in my case) model to support pass through mode.

Steve

[nemo_uk]

Apparently you can change the settings in the heli (TREX600N in my case) model to support pass through mode.

one of these days I'll get around to reading the manual for the DX7 :o