Tranmitter Interface, two different Futaba 6XAs

[JimH]

They used to work uder Win98/RFD

Well, I have tried very combination of Parallel port BIOS settings, IRQ's, Normal, ECP, EPP, ECP/EPP..etc...to no avail..have installed SP!, no avaiol....yuck, yuck...frustrated...

thanks in adavcen for any pointers...

[realfreak]

As i said in another post, i run Win 2000 with my interface which works good with both a T6XA and a 8UAPS. here is the config:

Just my 2 cents, i have Windows 2000 here and my interface is working very good. Here is my configuration: ECP printer port on LPT1 . in the port settings tab, in the filter ressource method, the checkbox ''never use an interrupt'' is checked. the ''enable legacy plug and play detection'' box is unchecked. in the ressource tab, there is : Inpout/Outpout range: 0378-037F
Inpout/Outpout Range: 0778-077B
Direct memory Access: 03
The ''use automatic settings'' checkbox is checked.
that's all about my config. Try this and report if it worked for you.

Hope this helps!

Happy landings !!!

Happy landings !!!

[JimH]

This is the only combo that worked for me as well now..have spent a couple days trying it out...realfreaks combination worked for me first shot...noticed it when the bars actually moved when in calibration !!

-----------
configuration: ECP printer port on LPT1 . in the port settings tab, in the filter ressource method, the checkbox ''never use an interrupt'' is checked. the ''enable legacy plug and play detection'' box is unchecked. in the ressource tab, there is : Inpout/Outpout range: 0378-037F
Inpout/Outpout Range: 0778-077B
Direct memory Access: 03
The ''use automatic settings'' checkbox is checked.
----------

[kyosho46vr]

Those are my exact Win2000 settings and after I install G2 w/interface and reboot I never get back into Win2000

Ned