View Single Post
Old 12-30-2013, 05:48 PM
opjose's Avatar
opjose opjose is offline
Registered User
Join Date: Nov 2005
Location: Third rocky planet.
Posts: 13,220
The "No Controller detected" is the standard message you see if the transmitter is not sending a PPM signal to the Realflight interface.

So you must first make sure that your transmitter is set to function as a buddy box.

You must enable PPM mode and permit all of the controls to be switchable from the master to the slave and vice versa.

Once done TURN OFF your transmitter and plug the interface cable in.

With most ( but not all ) transmitters, you must have the TX OFF for them to function as a buddy box, which is what the Realflight Interface uses.
Newbies please click here for important instructions about forum posts: CLICK ME!
Reply With Quote