View Single Post
  #43  
Old 10-23-2009, 02:22 PM
Lectrictech Lectrictech is offline
Registered User
 
Join Date: Mar 2009
Posts: 3
Potentiometer Help

I had my controler hinge pin for the elevator stick break a couple months back so I drilled the gimbal housing and inserted a small rivet with CA and all has been fine. Now I noticed no throttle control. Upon inspection I noticed the Pot. has come apart. I tried to reafix the back with thick CA but it wont hold. Does anyone know the Ohm Value for this Pot? I tried some from Radio Shack and the values must be too low because it requires +- 270 degrees to get from idle to full throttle. Obviously the stick travel is +- 45 degrees. My existing one is broken to the point I cannot use it for the test.

Last edited by Lectrictech; 10-23-2009 at 02:27 PM. Reason: Additional info
Reply With Quote