Opjose Hangar 9 Arrow edit problem

[DonaldT]

I downloaded the Opjose edit of the Hangar 9 Arrow after reinstalling 4.5 and his plane spawns with the engine off. I don't remember it doing that before. I checked all the obvious stuff; there is 11 ounces of fuel in the tank and none of the switches start the engine.

I have already tried downloading again and reinstalling.

Any advice?

P.S. Flip3D did an edit of it too, can't find it anymore on the swaps.


Donald

Thanx in advance

[doug schluter]

here is the one you're looking for .

http://www.knifeedge.com/forums/down...=file&id=14681

[brields]

Perhaps you should send a PM to Opjose?

[dhk79]

Often this occurs when the prop has been inadvertently edited to be too large and what really happens is a prop strike right as the plane spawns. It is unlikely that it would spawn with a dead engine, so something is killing it.

[opjose]

Yup... somewhere along the way the prop was changed during one of the upgrades.

I never bothered revisiting that plane because Flip did a pretty good job with his.

[DonaldT]

Thank you for your replies.

The Flip3D arrow doug pointed to is for G5; I only have 4.5.

I will try editing the prop.

Thanx.

Donald