|
|
|
|
|
|||||||
| Use of this site is subject to our Terms of Use. | Looking for technical support? Read this! |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
12-08-2006, 12:15 PM
|
||||
|
||||
|
3.448 & 3.5 on the same PC ?
After reading quite a few concerns about problems with 3.5 and difficulty in rolling back to 3.448. I'm a little reluctant to jump in.
Is it possible to install a second copy of G3 on the same PC and then upgrade the second to 3.5 leaving the other copy intact? This way you would be able to decide wether to run 3.4 or 3.5 from your desktop. 
|
|
#2
12-08-2006, 01:02 PM
|
||||
|
||||
|
|
|
#3
01-08-2007, 05:51 PM
|
||||
|
||||
I did it
I updated to 3.5 and was unsure about how some of the planes were handling, so I went down to 3.448 again, and all i had to do was upgrade (downgrade) to specific version in the realflight launcher. It was no problem, apart from the planes that I imported to 3.5 acted funny, but that only takes a few mins to correct with wonderful knifeedge here. I'm am back to 3.5 now though. I'm undecided which i like better
__________________
www.exboardusa.com
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
