I must be missing something, or have I installed RF7.5 incorrectly? I created a copy of the Quadcopter X model, but when I go to the Component tab in the Edit tool, all editing options are grayed out.It is not possible to import files from realflight Drone to realflight 7.5.
It is possible to add cameras to any of the aircraft in 7.5 though and many of the multirotors already have gimbal mounted cameras installed.
The component tab, pertains "Specifically", to the lower Tab you have selected, and the selected location (highlighted), there in.
e.g. If the "Physics tab>Fuselage>Fuselage" is selected, the "Component>Add" will give you, a list of physical components, you can add, to That Parent.
Like a Camera, or, Movable Pod, Camera.
Add, and Adjust to your specified X,Y,Z coordinates, angles, etc. Movable Pods require setup, for movement control.
Load the Stock "Quadcopter". In the editor, you can check out a camera setup, with Tilt Ch 8, and Swivel Ch 6. Reverse Engineer to fit your needs.
Note Stock Aircraft files are protected. You cant screw up a stock file. If you make changes to a stock file, before you are allowed to exit the editor, you are prompted to Name the "New File". This will Create a New File, while Preserving the Stock, Unchanged File
If you leave the editor, with out saving files, no harm, no foul. Files will revert back, to the state they were, when you first opened the Editor.
It's not what aircraft you're using but what airport.Thanks a million for the assistance. I'm getting the hang of this a little at a time.
Next issue: when I load the H4 Quadcopter, a Live FPV Feed is attached to the fuselage. When I go the Views... Camera however, the Live FPV Feed (F4) is grayed out. I have a similar situation with all drones I have loaded, it seems. How do I get the F4 view enabled?